RV Touch-Up Hints
Simple, inexpensive ways to make scratches, nail holes, and nicks disappear.
Many small touches can improve the appearance of your RV. A can of spray paint, for instance, applied properly after a quick wire-brushing, can spruce up a weathered hitch, frame, and entry step a great deal.
Inside the rig, RV interiors are full of woodwork and thin wall paneling that get scratched or nicked easily from everyday travel. Fortunately, there are several simple products on the market that can cover up those defects and make them practically disappear.
Fixing Nail Holes in White Paneling & Ceilings
- Correction Fluid ("White-Out"): One of the handiest tricks is common correction fluid used for paper. It comes in a small bottle with a brush attached to the cap and costs just a couple of bucks. Nail or staple holes in white wallpaper, paneling, or ceiling areas are easily filled with it, leaving an almost invisible repair. (I've heard white toothpaste will also work in a pinch, though I've never tried it myself.)
- Squeeze-Tube Drywall Filler: You can also pick up a ready-mixed white spackling filler in a squeeze tube. It is easy to apply, dries to a hard finish, and can be gently sanded to blend right in.
Hiding Scratches in Woodwork & Colored Paneling
For darker wood tones like oak, walnut, or cherry, pick up a set of colored wood filler sticks or repair markers matched to your paneling. They cover small holes and gouges with ease.
For light surface scratches, a tiny dab of matching wood stain will often hide the mark and blend right into the finish. Just be sure to test any stain or marker in an inconspicuous spot—like inside a closet or behind a cabinet door—before using it out in the open.
Covering Larger Holes
If you're dealing with a hole too big for filler, get creative with placement. Depending on where it is located, larger holes can be cleanly covered by hanging a picture, mounting a coat hook, or adding a small wall accessory. You can also run a matching batten strip (the thin trim strips RV builders use over wall seams) in the same finish as the wall—if it matches, it looks completely factory.
With a little ingenuity, most interior and exterior blemishes can be made invisible.
Tech Tip: Before using spray paint on your trailer's tongue, A-frame, or steps, knock off any loose rust with a wire brush and wipe the metal down with a clean rag. A quick coat of rust-inhibiting satin black enamel will keep it looking sharp all season.
See also:
- RV Storage Compartment Locks & Security – Upgrading CH751 locks and adding compartment lighting.
- RV Wheel Chocks & DIY Stabilizers – Stopping the "rock and roll" movement in your parked trailer.
- RV Carbon Monoxide Safety & Detector Guide – Protecting your rig from invisible CO buildup.